Alle Ergebnisse (377)

Auswählen Bild Teile-Nr.
 Herst.
Beschreibung Datenblatt Verfügbarkeit Preis (CHF) Ergebnisse in der Tabelle nach dem Einheitspreis bei Ihrer Menge filtern.
Menge RoHS
Marki Microwave Signalaufbereitung The T3-1040G is a high performance mixer featuring LO/RF from 10 to 40 GHz and IF from 1 to 18 GHz.
Datenblatt
2erwartet ab 13.01.2027
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung The T3-12 is a high performance mixer featuring LO/RF from 10 MHz to 12 GHz and IF from 1 MHz to 4 GHz.
Datenblatt
3erwartet ab 11.09.2026
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung The T3-20G is a high performance mixer featuring LO/RF from 10 MHz to 20 GHz and IF from 1 MHz to 10 GHz.
Datenblatt
1erwartet ab 21.08.2026
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A broadband balun, hand-tuned for optimal phase and amplitude balance over a 200 kHz to 10 GHz bandwidth.
Datenblatt
1erwartet ab 01.09.2026
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung This general purpose high pass filter offers high stop band suppression and low insertion loss in the passband. These filters can be used to eliminate unwanted side bands during up-conversion or for removing spurious interference and noise.
Datenblatt
1erwartet ab 31.08.2026
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung The MM1-1857H is a passive double balanced MMIC mixer. It features excellent conversion loss, superior isolations and spurious performance across a broad bandwidth, in a highly miniaturized form factor.
Datenblatt
1erwartet ab 15.12.2026
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A resistive 2-way power divider that features broadband operation from DC to 30 GHz. Resistive power dividers offer 6 dB nominal insertion loss and excellent amplitude and phase balance.
Datenblatt
1erwartet ab 08.01.2027
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A resistive 2-way power divider that features broadband operation from DC to 40 GHz. Resistive power dividers offer 6 dB nominal insertion loss and excellent amplitude and phase balance.
Datenblatt
1erwartet ab 02.10.2026
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung 2-Way Wilkinson power dividers can be used for both in-phase power splitting and power combining applications.
Datenblatt
1erwartet ab 13.11.2026
Min.: 1
Mult.: 1

Marki Microwave RF-Entwicklungstools The EVAL-MT3H-0113H is a connectorized evaluation board for the MT3H-0113HSM passive MMIC Surface mount 1.5 - 13 GHz High Dynamic Range Mixer.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 2 Wochen
Min.: 1
Mult.: 1

Marki Microwave RF-Entwicklungstools The EVB-MDPX-0305P is a connectorized evaluation board for the MDPX-0305PSM is a MMIC surface mount diplexer capable of multiplexing low frequency DC to 3 GHz and high frequency 5 to 26.5 GHz signals.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 2 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung The MFHP-00001BH MMIC highpass filter is an ideal solution for small form factor, high rejection filtering. The MFHP-00001BH features a 1.9 GHz 3 dBc cutoff frequency and 16 dB passband return loss. Available in a connectorized bullet housing.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 12 Wochen
Min.: 1
Mult.: 1

Marki Microwave HF-Mixer The MM1-0832LSM is a GaAs MMIC double balanced mixer that is optimized for high frequency applications. MM1-0832LSM is a high frequency X band mixer that works well as both an up and down converter through Ka band.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 10 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A broadband MMIC LO buffer amplifier that is capable of producing at least +18 dBm up to 67 GHz. This amplifier can be used to drive L- or H-diode mixers from 35-67 GHz, or L- or H-diode IQ mixers from 35-60 GHz.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung The ADA-1030 can be used as a frequency extender to enhance the frequency range of a <15 GHz synthesizer up to 30 GHz. Useful for lab testing, test and measurement, and prototype systems.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A wideband low noise amplifier capable of providing 24 dB gain and a low 1.3 dB typical noise figure from 6 to 20 GHz. The ADM-8556 is an ideal linear signal amplifier for applications requiring low power consumption and small form-factors.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung The ADM-8558 is a wideband distributed low noise amplifier capable of providing 16 dB gain and +23 dBm OIP3 from 0.005 to 20 GHz and a low 1.8 dB typical noise figure from 7 to 15 GHz.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A high-linearity low noise amplifier capable of providing 15 dB gain, 2.1 dB noise figure and +27 dBm OIP3 from 300 kHz to 10 GHz. It can serve either as a linear signal amplifier, or as a saturated driver amplifier for H- or S-diode mixers.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A high-linearity, low noise amplifier capable of providing 10.5 dB gain and +26 dBm OIP3 across a broad 0.2-20 GHz bandwidth.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung The ADM-8625PC is a high-linearity low noise amplifier capable of providing 18 dB gain, 1.4 dB noise figure and +29 dBm OIP3 from 750 MHz to 8 GHz.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A high-linearity, high gain, low noise distributed amplifier capable of providing +22dBm output power up to 35 GHz. When driven with an input power of 0 to +5 dBm, it can provide sufficient LO drive to power all H and most S diode mixers to 40GHz.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave Signalaufbereitung A high-linearity amplifier capable of providing +18 dBm output power up to 10 GHz. The ADM1-8095PC can serve either as a linear signal amplifier, or as a saturated driver amplifier for H- or S-diode mixers.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave RF-Adapter - In Serien The ADPFKFK is a 2.92mm Female to 2.92mm Female straight angle coaxial adapter. This adapter features low insertion loss and low VSWR across a DC-40 GHz bandwidth. 3/8" torque wrench and 6 mm fixed wrench recommended.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1

Marki Microwave RF-Adapter - Zwischen Serien The ADPFVFK is a 2.4mm Female to 2.92mm Female straight angle coaxial adapter. This adapter features low insertion loss and low VSWR across a DC-40 GHz bandwidth. 3/8" torque wrench and 5.5 or 6 mm fixed wrench recommended.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1
Marki Microwave RF-Adapter - In Serien The ADPFVFV is a 2.4mm Female to 2.4mm Female straight angle coaxial adapter. This adapter features low insertion loss and low VSWR across a DC-50 GHz bandwidth. 3/8" torque wrench and 6 mm fixed wrench recommended.
Datenblatt
Nicht-auf-Lager-Vorlaufzeit 18 Wochen
Min.: 1
Mult.: 1